|
|
 |
|
|
ACT-RF124 |
|
|
 |
|
Description:
The RF124, RF204 and RF304 are A10 enhanced
powerline carrier receivers controlling a single remote
Form C Relay capable of switching a 30 amp
load.
The RF124, RF204 and RF304 will continuously
monitor the powerline for PCC signals, and adjust
their gain to filter out line noise. They will close or
open their relay via Standard or Extended X10
commands.
The RF124, RF204 and RF304 may be remote
controlled by addressing it by its base address or
its sub address, or through groups by the commands
ALL LIGHTS ON, ALL LIGHTS OFF, or ALL
UNITS OFF. These global commands must be
configured.
The RF124 will transmit the current relay status
when requested.
A status LED verifies power to unit, and guides
simple configuring procedure.
Features:
- Two way powerline communication. Reports ON/OFFstatus
upon "Status Request" and automatically
- Triac Output controlled by X10 On/Off, Bright/Dim or
Extended Code Preset Dim Signals
- X10 Standard Code (256 Addresses) and X10 compatible
Extended Addressing capability (4096 addresses)
- Two way powerline communication, reports status upon
"Status Request" for standard or extended addresses
- One latching 20 Amp Form A Relay with manual override and
mechanical status indicator - holds last state on power loss.
- Easy Push Button Configuring for Standard Unit Address
ON/OFF and:
- Response to "All Lights On" Command
- Response to "All Units Off" Command
- Response to "All Lights Off" Command
- Enable or disable "Polite Mode"
- Factory Configuring for Extended Unit Address ON/OFF and:
Response to "Status Request"
- Advanced A10 circuitry, X10 Signal Compatible
- Flying leads for field connection
Applications:
- Control High Current Loads
- Configure to alternate electrical loads
- Remote ON/OFF control of HVAC and Unitary Equipment
- Control Parking Lot Lights
- Lighting Circuits
|
|
|
|
|
|
|
